234
Initiating the tool as command line
The following explains how to initiate the backup tool as a command line.
CF_Backup.exe <option> <target>[<password>]
Parameters in the command line;
option
B: Specify the backup process.
R: Specify the restoration process.
In the <option> field, specify either B or R. Character of the selection to enter is not
case-sensitive.
target
Storage directory of backup file
password
A password to set up if required.
Notes:
• Depending on the size of data to back up or to restore, it may take a few ten seconds to a few
minutes.
• To carry out the backup and restoration processes, it is recommended to use the dedicated AC
Adaptor (AD-S42120B) to power the terminal via cradle.
To Next Page
Loading...
