PRINTING IMAGES
213
To configure print settings for all images
1.
In the PLAY mode, press [MENU].
2.
Select the “PLAY” tab, select “DPOF”, and
then press [왘].
3.
Use [왖] and [왔] to select “All images”, and
then press [왘].
4.
Use [왖] and [왔] to
specify the number of
copies.
• You can specify up to 99
for the number of copies.
Specify 00 if you do not
want to have the image
printed.
5.
To turn on date stamping for the prints, press
[DISP] so “On” is displayed.
•“On” indicates that date stamping is turned on.
• Turning on date stamping while “00” is specified for
the number of copies will cause the number of copies
to change to “01”. Any other number of copies setting
will remain the same when you turn on date
stamping.
• To turn off date stamping for the prints, press [DISP]
so “Off” is displayed.
6.
After all the settings are the way you want,
press [SET] to apply them.
IMPORTANT!
• DPOF settings are not cleared automatically after
printing is complete. This means that if you perform
another printing operation without clearing DPOF
settings, printing will be performed in accordance
with the last settings you configured. If you want to
prevent this from happening, perform the procedure
under “To configure print settings for all images” and
change the number of copies to “00”. After that, you
can configure new DPOF settings as required.
To Next Page
Loading...
Need help?
General
