20
Initialization
Entering diag mode
Password
During initialize operation, you can program the password for PGM 3 ~ 7. If it is set, every time you enter PGM 3 ~ 7
mode, you must input this password by the following procedure.
1. Press <#-1> (normally <CASH/AMT TEND>).
2. Enter password.
3. Press <#-2> (normally <SUBTOTAL>).
Otherwise, you can do nothing in the PGM 3 ~ 7 mode.
1. Plug the power cord into an AC outlet.
2. Hold down <JOURNAL FEED>.
3. Turn the mode switch to PGM position.
4. Release <JOURNAL FEED>.
5. Enter “99990000” and press <SUBTOTAL> to enter the diagnosis.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
RECEIPT
FEED
To Next Page
Loading...
