• Preamble Type: It has two options: Long and Short. In the case that the client (PC) supports
the Short type, the WLAN can have a better performance if it is Short.
• MAX Associations Limit: It refers to the maximum number of connections. It is used to set
the maximum number of concurrent WLAN users on the gateway. A maximum of 32
clients can connect with the gateway in wireless mode.
• Mode: It refers to the WLAN accessing mode. The gateway can work in two modes, as
shown in the following table. The default value is Access Point.
Mode
Wireless Bridge
Access Point
Description
It is used to connect two or more access points.
The access points meeting the IEEE 802.11b/g standard or
the wireless terminals can connect the wireless gateway.
• Bridge Restriction: It refers to the limitation to the peer MAC addresses. When it is Disabled,
the E961 can access all the remote bridges; when it is Enabled, the E961 can only access
the remote bridges that the addresses are in the address list.
• Bridges: It refers to the physical address of the remote peer bridge. The gateway supports
the point-to-multipoint (PTM) bridge mode, and a wireless gateway can connect four
remote peer bridges at the same time.
• Peer MAC Address: It refers to the physical address list of the remote peer bridges. It
contains a maximum of four physical addresses.
• Link Status: Up shows the successful connection and Down shows the failed
connection.
33
To Next Page
Loading...