3. Select other options as required, and then click
LAN MAC Filter
Your gateway supports MAC filtering based on a list of either denied or allowed computers.
A common method to restricting network access is to specify the Media Access Control
(MAC) address.
To locate the MAC address in Windows, choose Start > Run, and then enter cmd.
The command window is displayed, enter ipconfig /all, and then press Enter.
The MAC address is displayed as the Physical Address.
1. Click to access the LAN MAC Filter window.
2. Select MAC Filter Mode.
LAN IP Filter
You can configure the gateway to block specific IP addresses from accessing the LAN.
Click to access the IP Address Filter window.
36
.
Value
Disabled
Allow
Deny
Description
The MAC address filter function is disabled.
The clients with addresses in the MAC Address list are
allowed to connect with the gateway through the LAN.
The clients with addresses in the MAC Address list are not
allowed to connect with the gateway through the LAN.
3. Enter the MAC addresses of the clients and click
.
Adding an IP Address
1. Select the protocol and status.
2. Enter the IP address and corresponding port to be blocked from accessing the LAN.
3. Click to add the IP address to the table.
Modifying an IP Address
1. Click in the Modification column. The corresponding IP address filter is displayed.
2. Modify the contents as required.
3. Click .
Deleting an IP Address
Click in the Modification column. The corresponding IP address filter is deleted.
To Next Page
Loading...