CENTRALINE I/O MODULES – INSTALLATION & COMMISSIONING INSTRUCTIONS
21 EN1Z-0973GE51 R0119
Commissioning and Updating Firmware
Commissioning Panel Bus I/O Modules
During engineering, the HEX address of the Panel
I/O modules is defined.
NOTE: With Panel Bus I/O modules it is essential that
the HEX switch be set to the address assigned by
the engineering tool.
The CentraLine controller automatically commissions all
Panel Bus I/O modules.
Commissioning LONWORKS Bus I/O Modules
The commissioning of LonWorks Bus I/O modules is done
using the engineering tool.
Updating Software with Panel Bus I/O Modules
The CentraLine controller automatically updates all Panel
Bus I/O modules. Thus, whenever the controller’s firmware
is updated, the firmware of the Panel Bus I/O modules is
automatically updated, too.
Updating Software with LONWORKS Bus I/O
Modules
You can update the LONWORKS I/O modules using CARE or
EXCELON.
To Next Page
Loading...
Need help?
General
