4.1.6.1 PIRAC Override
The PIRAC (Beam Autoclose Mode) can be overridden in Standard and Reversing Modes.
Similar to overriding the Autoclose function you must press and hold the button of the
remote control or intercom gate release for at least six seconds. The gate response will
be to start opening and then to stop for a pause time of three seconds and then continue
to open as soon as the PIRAC Override feature is activated. Once the gate resumes
opening you may release the remote control button or intercom gate release and the
gate will continue to the fully open position with PIRAC Mode overridden.
Your gate will stay open until you use the remote control or intercom gate release to
close the gate. The D5-Evo DOMESTIC, D10 and the D10 Turbo will then revert to normal
PIRAC operation.
4.1.7. Holiday Lockout Mode
This feature completely immobilises
the operator and deactivates all
inputs so nobody can get into your
property while you are away.
One of the buttons on your remote
control can be used to switch the
Holiday Lockout Mode as well as a
latching keyswitch or keypad
mounted adjacent the gate entrance,
accessible from the outside of the
property.
When Holiday Lockout Mode is
enabled, any of the access control
devices that are connected to the
D5-Evo DOMESTIC, D10 and the
D10 Turbo, will be inactive and not
even tampering with the keyswitch,
keypad or access tag readers on the
outside of the property, will open
the gate – particularly useful if you
intend leaving your property
unattended for extended periods
of time.
Gate electronically locked
FIGURE 20
If Holiday Lockout Mode is enabled while the gate is moving or in the open position, it will
only activate when the gate is back in the closed position.
To Next Page
Loading...
