7. Diagnostics
Depending on the type of fault or condition of the motor, audible feedback will be given
via the onboard buzzer. Listen out for this and refer to the table below:
The dierent conditions are given in order of precedence.
Break-in Alarm – if the safety beams have been broken with this feature set, the
buzzer will emit a continuous tone for 30 seconds.
Ambush Alarm – if the safety beams have been broken with this feature set, the
buzzer will emit a continuous tone until the safety beams have been cleared.
Battery Low – Buzzer will emit three beeps every two seconds for 30 seconds. Refer
to section, Battery Low
Multiple collision – Buzzer will beep periodically until condition is cleared. Refer to
section, Anti-crushing, collision count
Holiday Lockout – If the Holiday Lockout has been enabled, when triggering
to operate the gate, the gate will not operate but the buzzer will emit one beep
periodically for 30 seconds
Emergency Stop – If the Emergency stop button has been activated, the buzzer will
emit buzzer will emit one beep periodically for 30 seconds
Time-barring - if a time-barred input or remote control is operated during a time-
barring period, in addition to the gate not reacting to the input being activated or the
remote control, the buzzer will emit one beep periodically for 30 seconds
Mains failure – If the mains supply to the charger has failed the buzzer will emit two
beeps every two seconds for 30 seconds
Safety beam broken – if something in the path of the beams the buzzer will emit
one beep periodically for 30 seconds
Safety beam failure – if the safety beams are not operating the buzzer will emit ve
beeps periodically for 30 seconds (beams test circuit must be enabled)
Contact Centurion Systems (Pty) Ltd or your gate automation specialist for assistance.
Do not attempt to repair the unit yourself. Any work performed by
unauthorised personnel may void the warranty.
DIAGNOSTICS SECTION 7
To Next Page
Loading...
