FEATURES AND FUNCTIONS
4.1.12. Intruder-detection Alarms
1
(a world rst)
4.1.12.1. Ambush Alarm
Once activated, if the opening or
closing beams are continuously
interrupted for a predened time,
the Ambush Alarm will sound.
Intruders often cover beams’ lenses,
thus breaking the beam, so your
gate stays open after you have
entered or left your property – but
with the Ambush Alarm enabled
you can be instantly alerted of any
criminal activity.
4.1.12.2. Break-In Alarm
If the closing beam on the outside of
your property is broken, the Break-
In Alarm will sound and continue
until 30 seconds have passed since
the beam is re-made.
Intruders will not be able to loiter
outside your property as the Break-
In Alarm will immediately alert you
of their presence – and the noise
of the onboard buzzer is often an
eective deterrent. Optionally the
alarm signal can be routed to an
armed response company.
FIGURE 26
FIGURE 27
If the Ambush Alarm or Break-In
Alarm is utilised, the system may be
congured to operate one of the
following outputs provided on the
controller:
• Onboard buzzer –
emits a continuous tone
• Pillar / Courtesy light contact
• Safety beam common
• Status LED output
• Auxiliary IO (which can be used to connect to a third party alarm and security
company, or a CENTURION G-Switch device to alert you of the alarm via SMS)
It is typical to select only one of the alarm features.
1. Requires infrared gate safety beams to be installed
Intruder masks safety beams,
30 seconds later
alarm is activated
Intruder breaks safety
beam while loitering
at gate, alarm immediately
activated for 30 seconds
Safety beam
Alarm
To Next Page
Loading...
