Centurion D10 - Courtesy (Pillar) Light Act as Warning Light; Onboard Multichannel Receiver; Pre-Open and Pre-Close Delay

page 31
www.CentSys.com
FEATURES AND FUNCTIONS SECTION 4
4.1.14.2. Courtesy (Pillar) Light acts as Warning Light
For additional safety, the Courtesy
(Pillar) Light output can be
congured to act as a Warning Light
before the gate operates and while
the gate is moving.
Contact your gate automation
specialist or Centurion Systems (Pty)
Ltd for more details on the dierent
Warning Light Modes.
FIGURE 30
4.1.14.3. Pre-open and Pre-close Delays
If you make use of the Warning Light feature, you can set your gate to have a slight
delay before it opens or closes to allow the light to warn pedestrians or vehicles that the
gate is about to move.
The Pre-open and Pre-close Delays can be independently set and can also be used
independently of the Warning Light feature referred to above.
4.1.15. Onboard Multichannel Receiver
The D5-Evo DOMESTIC, D10 and
D10 Turbo controllers are supplied
standard with a multichannel
receiver compatible with
CENTURION’s secure rolling code
(Keeloq
TM
encryption). The receiver
will allow any combination of the
dierent inputs (such as Trigger,
Pedestrian, Holiday Lockout, etc.)
to be operated from a single multi-
button remote control.
FIGURE 31
You can articially increase the number of buttons of a CENTURION multi-button remote
control by using a two button combination. One of the buttons is used as a shift button
to allow the other buttons to be used again in combination with this button. Press and
hold the shift button and then press one of the other buttons to create a new button.
The shift button cannot be used as a button on its own; it must always be used in
combination with another button.