Condensing Pool Heater Genie S
TECHNICAL DATA Inside cover
User Instructions 1
INTRODUCTION 3
Heater Location 3
Gas Supply 4
Conversion 4
Flueing 4
Air Supply 4
Outdoor Heaters 4
Flue Terminal Position 5
Condensate Drain 6
Pool Pump & Pipework 6
Winterisation 6
Electricity Supply 6
INSTALLATION OF HEATER 7
Procedure 7
Outdoor Terminal 7
Flue Systems 7
Wall Terminal 7
Flue Examples 12
Roof Terminal 12
Plumbing 12
Pressure Switch 12
Gas Conversion 13
Gas Connection 13
Condensate Connection 14
Electrical Connection 14
Commissioning 16
Control Setup 17
Multiple Heater Kit 18
Wall Mounting Kit 20
FAULT FINDING 23
Operation 23
Safety Controls & Lockouts 23
Engineering Mode 23
Test Temperature Disp.Mode 23
Display Fault Codes 24/26
SERVICING 25
Routine Service 27
Changing Components 27
Spares 30
Heater Components 31
List of Figures
Page
Fig 1.0 Flue Terminal Positions 5
Fig 2.0 Hydraulic Resistance Graph 6
Fig 3.0 Outdoor Terminal Fixing 7
Fig 3.1 Service Access &
Pipe Connections 8
Fig 3.2 Wall Terminal Dimensions 8
Fig 3.3 Outdoor Terminal Dimensions 9
Fig 3.4 Roof Terminal Dimensions 9
Fig 4.0 Wall Terminal Installation 10
Fig 4.1 Extended Wall Terminal
Installation 10
Fig 4.2 Extended Vertical Roof
Installation 10
Fig 4.3 Outdoor Terminal Installation 10
Fig 5.0 Pressure Switch 12
Fig 6.0 Throttle Adjustment 13
Fig 6.1 Orifi ce Position 13
Fig 6.2 Gas Valve Tappings 14
Fig 7.0 Condensate Disposal 15
Fig 7.1 Condensate Syphon 15
Fig 8.0 Heat Exchanger Air Vent 16
Fig 8.1 Pump Priming Button 16
Fig 8.2 Heat Exchanger Sight Glass 16
Fig 9.0 Controls 17
Fig 10.0 Multiple Heater Install 18
Fig 10.1 Multiple Heater Install 18
Fig 10.2 Multiple Heater Install 19
Fig 10.3 Wall Mounted Heater 20
Fig 10.4 Wall Mounting Dimensions 20
Fig 10.5 Wall Mounting Assembly 21
Fig 11.0 Schematic Wiring 22
Fig 12.0 Electrode gap setting 27
Fig 13.0 Electrical Components 30
Fig 14.0 Heater Components 31
Section Page
Contents
To Next Page
Loading...
