SECTION 4 CESSNA
NORMAL PROCEDURES MODEL T182T NAV III
GFC 700 AFCS
U.S.
BEFORE TAKEOFF (Continued)
15. A/P TRIM DISC Button - PRESS (verify autopilot disengages
and aural alert is heard)
16. Flight Director - OFF (push FD button on either PFD or MFD
bezel)
17. Elevator and Rudder Trim Controls - SET FOR TAKEOFF
18. Throttle Control - 1800 RPM
a. MAGNETOS Switch - CHECK (RPM drop should not
exceed 175 RPM on either magneto or 50 RPM differential
between magnetos)
b. Propeller Control - CYCLE (from high to low RPM; return to
high RPM) (push full in)
c. VAC Indicator - CHECK
d. Engine Indicators - CHECK
e. Ammeters and Voltmeters - CHECK
19. Annunciators - CHECK (verify no annunciators are shown)
20. Throttle Control - CHECK IDLE
21. Throttle Control - 1000 RPM or LESS
22. Throttle Control Friction Lock - ADJUST
23. COM Frequency(s) - SET
24. NAV Frequency(s) - SET
25. FMS/GPS Flight Plan - AS DESIRED
Check GPS availability on AUX-GPS STATUS page. No
annunciation is provided for loss of GPS2.
26. XPDR - SET
(Continued Next Page)
T182TPHBUS-01
4-16