CESSNA SECTION 7
MODEL T182T NAV III AIRPLANE AND SYSTEM DESCRIPTION
GFC 700 AFCS
U.S.
INSTRUMENT PANEL (Continued)
PILOT PANEL LAYOUT (Continued)
Switches for the airplane electrical systems and equipment are found
on an internally lighted subpanel found below the lower left corner of
the PFD. Each switch is labeled for function and is ON when the handle
is in the up position. See the ELECTRICAL EQUIPMENT descriptions
in this section for further information.
The circuit breaker panel is found along the lower edge of the pilot's
instrument panel below the electrical equipment switch panel and pilot
control wheel column. Each circuit breaker is identified for the
equipment or function it controls and for the bus from which it receives
power. Lighting for this subpanel is controlled using the SW/CB
PANELS dimmer control. See the ELECTRICAL EQUIPMENT
descriptions in this section for further information.
CENTER PANEL LAYOUT
The Garmin audio panel is found on the upper half of the center
instrument panel, immediately to the right of the PFD. A pushbutton
switch labeled DISPLAY BACKUP to manually select display reversion
mode is found on the lower face of the audio panel. Refer to the Garmin
G1000 CRG for operating information.
The MFD is found on the upper center panel to the right of the audio
panel. The MFD depicts EIS information along the left side of the
display and shows navigation, terrain, lightning and traffic data on the
moving map. Flight management or display configuration information
can be shown on the MFD in place of the moving map pages. Refer to
the Garmin G1000 CRG for operating information.
(Continued Next Page)
T182TPHBUS-00
7-11
To Next Page
Loading...
Need help?
General
