CESSNA SECTION 8
MODEL T182T NAV III AIRPLANE HANDLING, SERVICE
GFC 700 AFCS AND MAINTENANCE
U.S.
CLEANING AND CARE (Continued)
ENGINE CARE
The engine may be cleaned, using a suitable solvent, in accordance
with instructions in the airplane Maintenance Manual. Most efficient
cleaning is done using a spray type cleaner. Before spray cleaning,
ensure that protection is afforded for components which might be
adversely affected by the solvent. Refer to the airplane Maintenance
Manual for proper lubrication of controls and components after engine
cleaning. The induction air filter should be replaced when its condition
warrants, not to exceed 500 hours.
INTERIOR CARE
To remove dust and loose dirt from the upholstery and carpet, clean the
interior regularly with a vacuum cleaner.
Blot up any spilled liquid promptly with cleansing tissue or rags. Don't
pat the spot; press the blotting material firmly and hold it for several
seconds. Continue blotting until no more liquid is taken up. Scrape off
sticky materials with a dull knife, then spot clean the area.
Oily spots may be cleaned with household spot removers, used
sparingly. Before using any solvent, read the instructions on the
container and test it on an obscure place on the fabric to be cleaned.
Never saturate the fabric with a volatile solvent; it may damage the
padding and backing materials.
Soiled upholstery and carpet may be cleaned with foam type detergent,
used according to the manufacturer's instructions. To minimize wetting
the fabric, keep the foam as dry as possible and remove it with a
vacuum cleaner.
For complete information related to interior cleaning, refer to the
Maintenance Manual.
(Continued Next Page)
T182TPHBUS-00 8-27
To Next Page
Loading...
Need help?
General
