CESSNA SECTION 8
MODEL T182T NAV III AIRPLANE HANDLING, SERVICE
GFC 700 AFCS AND MAINTENANCE
U.S.
INTRODUCTION
This section contains factory recommended procedures for proper
ground handling and routine care and servicing of your airplane. It also
identifies certain inspection and maintenance requirements which must
be followed if your airplane is to retain that new airplane performance
and dependability. It is important to follow a planned schedule of
lubrication and preventive maintenance based on climatic and flying
conditions encountered in your local area.
Keep in touch with your local Cessna Service Station and take
advantage of their knowledge and experience. Your Cessna Service
Station knows your airplane and how to maintain it, and will remind you
when lubrications and oil changes are necessary, as well as other
seasonal and periodic services.
The airplane should be regularly inspected and maintained in
accordance with information found in the airplane maintenance manual
and in company issued service bulletins and service newsletters. All
service bulletins pertaining to the airplane by serial number should be
accomplished and the airplane should receive repetitive and required
inspections. Cessna does not condone modifications, whether by
Supplemental Type Certificate (STC) or otherwise, unless these
certificates are held and/or approved by Cessna. Other modifications
may void warranties on the airplane since Cessna has no way of
knowing the full effect on the overall airplane. Operation of an airplane
that has been modified may be a risk to the occupants, and operating
procedures and performance data set forth in the POH may no longer
be considered accurate for the modified airplane.
T182TPHBUS-01 8-3
To Next Page
Loading...
Need help?
General
