EasyManuals Logo

Cessna skylance tc T182T User Manual

Cessna skylance tc T182T
396 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
CESSNA SECTION 3
MODEL T182T NAV III EMERGENCY PROCEDURES
GFC 700 AFCS
U.S.
ELECTRICAL POWER SUPPLY SYSTEM
MALFUNCTIONS (Continued)
LOW VOLTS ANNUNCIATOR COMES ON BELOW 1000
RPM
1. Throttle Control - 1000 RPM
2. LOW VOLTS Annunciator - CHECK OFF
LOW VOLTS ANNUNCIATOR REMAINS ON AT 1000 RPM
3. Authorized maintenance personnel must do electrical system
inspection prior to next flight.
LOW VOLTS ANNUNCIATOR COMES ON OR DOES NOT
GO OFF AT HIGHER RPM
1. MASTER Switch (ALT Only) - OFF
2. ALT FIELD Circuit Breaker - CHECK IN
3. MASTER Switch (ALT and BAT) - ON
4. LOW VOLTS Annunciator - CHECK OFF
5. M BUS VOLTS - CHECK 27.5 V (minimum)
6. M BATT AMPS - CHECK CHARGING (+)
IF LOW VOLTS ANNUNCIATOR REMAINS ON
7. MASTER Switch (ALT Only) - OFF
8. Electrical Load - REDUCE IMMEDIATELY as follows:
a. AVIONICS Switch (BUS 1) - OFF
b. PROP HEAT Switch - OFF
c. PITOT HEAT Switch - OFF
d. BEACON Light Switch - OFF
e. LAND Light Switch - OFF (use as required for landing)
f. TAXI Light Switch - OFF
g. NAV Light Switch - OFF
h. STROBE Light Switch - OFF
i. CABIN PWR 12V Switch - OFF
(Continued Next Page)
T182TPHBUS-00
3-19

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cessna skylance tc T182T and is the answer not in the manual?

Cessna skylance tc T182T Specifications

General IconGeneral
BrandCessna
Modelskylance tc T182T
CategoryToy
LanguageEnglish

Related product manuals