SECTION 3 CESSNA
EMERGENCY PROCEDURES MODEL T182T NAV III
GFC 700 AFCS
U.S.
ELECTRICAL POWER SUPPLY SYSTEM
MALFUNCTIONS (Continued)
HIGH VOLTS ANNUNCIATOR COMES ON OR M BATT
AMPS MORE THAN 40
(Continued)
j. COM1 and NAV1 - TUNE TO ACTIVE FREQUENCY
k. COM1 MIC and NAV1 - SELECT (COM2 MIC and NAV2 will
be inoperative once AVIONICS BUS 2 is selected to OFF)
When AVIONICS BUS 2 is set to OFF, the following items
will not operate:
l. AVIONICS Switch (BUS 2) - OFF (KEEP ON if in clouds)
3. Land as soon as practical.
Make sure a successful landing is possible before
extending flaps. The flap motor is a large electrical load
during operation.
(Continued Next Page)
Autopilot Audio Panel
COMM 2 NAV 2
Transponder MFD
T182TPHBUS-00
3-18
To Next Page
Loading...
Need help?
General
