CESSNA SECTION 2
MODEL T182T NAV III OPERATING LIMITATIONS
GFC 700 AFCS
U.S.
FAA APPROVED
INTRODUCTION
Section 2 includes operating limitations, instrument markings, and
basic placards necessary for the safe operation of the airplane, its
engine, standard systems and standard equipment. The limitations
included in this section and in Section 9 have been approved by the
Federal Aviation Administration. Observance of these operating
limitations is required by Federal Aviation Regulations.
• Refer to Supplements, Section 9 of this Pilot's Operating
Handbook for amended operating limitations, operating
procedures, performance data and other necessary
information for airplanes equipped with specific options.
• The airspeeds listed in Figure 2-1, Airspeed Limitations,
and Figure 2-2, Airspeed Indicator Markings, are based
on Airspeed Calibration data shown in Section 5 with the
normal static source. If the alternate static source is
being used, ample margins should be observed to allow
for the airspeed calibration variations between the
normal and alternate static sources as shown in Section
5.
The Cessna Model No. T182T is certificated under FAA Type
Certificate No. 3A13.
T182TPHBUS-00 2-3
To Next Page
Loading...
Need help?
General
