21
NOTES:
• Severe or high cycle usage will require more frequent maintenance checks.
• Limits may have to be reset after any major drive chain adjustments.
• If lubricating chain, use only lithium spray. Never use grease or silicone spray.
• Over time, the drive chain on the operator will stretch and need to be tightened. To tighten the drive chain adjust either of the two chain eye bolts.
The chain should have no more than 1 inch of sag for every 10 feet of chain length.
• It is suggested that while at the site voltage readings be taken at the operator. Using a digital voltmeter, verify that the incoming voltage to the
operator is within ten percent of the operator’s rating.
MAINTENANCE
Disconnect all power to the operator before servicing.
DESCRIPTION TASK
CHECK AT LEAST ONCE EVERY
MONTH 6 MONTHS
Entrapment Protection Devices Check and test for proper operation X
Warning Signs Make sure they are present X
Manual Disconnect Check and test for proper operation X
Drive Chain and Sprockets Check for excessive slack and lubricate X
Belt and Pulley Check for excessive slack, wear or damage X
Gate Inspect for wear or damage X
Accessories Check all for proper operation X
Electrical Inspect all wire connections X
Chassis Mounting Bolts Check for tightness X
Operator Inspect for wear or damage X
MAINTENANCE
This manual downloaded from http://www.manualowl.com