11
• BEFORE attempting to install, operate or maintain the
operator, you must read and fully understand this manual
and follow all safety instructions.
• DO NOT attempt repair or service of your gate operator
unless you are an Authorized Service Technician.
When you see these Safety Symbols and Signal Words on the
following pages, they will alert you to the possibility of serious
injury or death if you do not comply with the warnings that
accompany them. The hazard may come from something
mechanical or from electric shock. Read the warnings carefully.
When you see this Signal Word on the following pages, it will
alert you to the possibility of damage to your gate and/or the gate
operator if you do not comply with the cautionary statements that
accompany it. Read them carefully.
IMPORTANT NOTE
SPECIFICATIONS AND WARNINGS
Overview and Specifications ............................ 2
Model Classification .................................. 3
Safety Installation Information .......................... 4
Gate Construction Information .......................... 5
Safety Precautions ................................... 6
Suggested Safety Protection Device Locations.............7-8
INSTALLATION
Installation Setups ................................... 9
Safety Catch Rollers and Gate Rail Stops ................. 10
Mounting Operator .................................. 11
Chain Installation Types .............................. 12
Control Board Description ............................ 13
Surge Suppressor Terminal Connections ................. 14
WIRING
Earth Ground Rod Installation ......................... 15
120Vac Power Connection ............................ 16
Heater Power Connection ............................. 16
Linking Master/Second Operators ...................... 17
Solenoid/Maglock Connection ......................... 18
Factory Installed DC2000™ Connection ................19-20
Plug-In Loop Detector Wiring.......................... 21
120Vac External Loop Detector Wiring................... 22
Entrapment Protection Devices (Contact Sensors).......... 23
Entrapment Protection Devices (Non-Contact Sensors) ...... 24
Omni Option Board Connections (Optional) ............... 25
ADJUSTMENTS
Set Gate Opening Direction............................ 26
Limit Switch Adjustments............................. 26
315 MHz 24Vdc Radio Receiver Programming...........27-28
Setting the Timer (On, Off) ............................ 29
Adjusting Reversing Sensor(s) ......................... 30
MAINTENANCE AND OPERATION
Maintenance ....................................... 31
OPERATION
Built-In Reset Switch ................................ 32
Audio Alarm ....................................... 32
EMERGENCY MANUAL RELEASE ................ 33
ACCESSORIES
...................................
34
WIRING DIAGRAMS
...........................
35-42
TROUBLESHOOTING
...........................43-44
REPAIR PARTS
Repair Part Illustrations .............................. 45
How to Order Repair Parts ............................ 46
Part Names and Numbers............................. 46
INSTALLATION CHECKLIST
....................... 47
WARRANTY POLICY
.............................. 48
Mechanical
Electrical
TABLE OF CONTENTS
WARNING
WARNING
CAUTION
ENGLISH
SPANISH
ADVERTENCIA
ADVERTENCIA
PRECAUCIÓN
ADVERTENCIA
WARNING
WARNING
WARNING
CAUTION
ENGLISH
SPANISH
ADVERTENCIA
ADVERTENCIA
PRECAUCIÓN
ADVERTENCIA
WARNING
WARNING
WARNING
CAUTION
ENGLISH
SPANISH
ADVERTENCIA
ADVERTENCIA
PRECAUCIÓN
ADVERTENCIA
WARNING
To Next Page
Loading...
Need help?
General
