255.0.0.0. It is important to ensure that Art-Net data using the 2.x.x.x IP address scheme is not
routed onto the internet.
Ideally you should set up a separate network between your QuickQ console and node(s).
Unlike normal office networks, the IP address must be in the range 2.x.x.x or 10.x.x.x, where x
is between 0 and 255.
The subnet mask must be set to 255.0.0.0. This means configuring the address of each piece of
equipment on the network manually. QuickQ products are typically set to 10.x.x.x. from the
factory.
2021-03-12
QuickQ v6
65
To Next Page
Loading...
