50
4.2.5 Steering Calibrations
Before performing the calibration, please make sure that there is no abnormality in
the satellite signal and accuracy, please refer to Main interface - 3 GNSS mode and
position accuracy for details.
4.2.5.1 Installation Settings
a) Set the basic information
A: Vehicle type: Currently support Front Steer, Rear Steer, Tracked, Articulated and
Transplanter Steer.
B: Steering Controller: Currently support Hydraulic Drive and Motor Drive.
C: Wheel Angle Sensor: Currently support Potentiometer, GAsensor Device, Without
WAS and Without WAS-Rice transplanter.
Note: Different vehicle types and wheel angle sensor types have different calibration
methods, please follow the prompts to complete the calibration.
The following is an example of calibration with a conventional installation type (Front
Steer + Motor Drive + GASensor).
To Next Page
Loading...
