INST.No.INE-868G [DB600] General Instruction Manual
- 104 -
5-10 MODEa [Communication parameter]
5-10-1
Setting overview
MODEa provides the communication related settings. The display is available only for the specification
with communication interface.
This section describes the settings only. Read the separate instruction manual "Communication Interface"
for general instructions for handling.
5-10-2
Setting item screen and function
Setting item Function
□□
▲
SEL
↑ ↓
▼
SEL
Initial screen
MODEa initial screen
(Communication
parameter)
MODEa (communication parameter) initial screen
Pressing the [
∨
] key makes a switch to the MODE7 or MODE6 screen.
Pressing the [
∧
] key makes a switch to the MODEb or MODEc screen.
No parameter is set by the [ENT] key.
[Switch to operation initial screen]
Press and hold the [MODE] key to display the screen set on the MODEt operation
initial screen.
□□
▲
SEL
↑ ↓
▼
SEL
Communication setting
Communication
protocol
Sets the communication protocol.
"
□□
"
MODBUS RTU protocol
"
"
MODBUS ASCII protocol
"
"
Private protocol
Use the [
∨
], [
∧
] and [ENT] keys to set the communication protocol.
□
□□
▲
SEL
↑ ↓
▼
SEL
Communication
function
Sets the communication function.
"
□□
"
Host communication
"
"
Digital transmission
"
"
Digital remote input
* Enabled only in constant value operation ("Program/constant
value operation switch" set to "OFF")
Use the [
∨
], [
∧
] and [ENT] keys to set the communication function.
□□□□
▲
SEL
↑ ↓
▼
SEL
Instrument No. Sets the instrument No.
"
□□□□
"
to
"
□□□
"
Instrument No. 1 to 99
Use the [
∨
], [
∧
] and [ENT] keys to set the instrument No.
Use the [>] key to move the cursor to the right digit.
□
□
▲
SEL
↑ ↓
▼
SEL
Communication
transmission rate
Sets the communication transmission rate.
"
□
"
4800bps
"
□
"
9600bps
"
"
19200bps
"
"
38400bps
Use the [
∨
], [
∧
] and [ENT] keys to set the communication transmission rate.
To Next Page
Loading...