Chino DB600 Series - IR Engineering Cable (RZ-EC5) Connection

INST.No.INE-868G [DB600] General Instruction Manual
- 142 -
6-12-2 IR engineering cable (RZ-EC5) connection
Port setup
Set "Port switch (MODEt)" to "Ir".
Connection
Install RZ-EC5 on a front of the instrument and check that RZ-EC5 is connected and fixed to the
instrument surely.
[DB650]
[DB670]
Installation/ Removal
To attach RZ-EC5, pick circled part (refer to the figure below) of the RZ-EC5 and put upper claw into
a groove of the instrument then put bottom claw to
(1) direction. To remove, pull down lightly to (2)
direction to remove the bottom claw.
[DB650] [DB670]
Caution
If RZ-EC5 is removed forcibly without following the direction
above, it may result in scratch on the device.
PC with USB port
*For compatible OS, refer to
the instruction manual of
RZ-EC5.
USB connector
A type (plug)
USB connector
Mini B type (plug)
USB connector
A type (plug)
USB connector
Mini B type (plug)