Chino DB600 Series - 4-4 Program operation; 4-4-1 Setting overview; 4-4-2 Setting item screen and function

INST.No.INE-868G [DB600] General Instruction Manual
- 52 -
4-4 Program operation
4-4-1 Setting overview
Allows you to monitor/operate the program operation screen.
4-4-2 Setting item screen and function
Setting item Function
□□ 
□□□

▲
SEL ↑ ↓ ▼ SEL
Operation initial screen
PV/SV Displays the measured value (PV).
"

"
to
"

"
Measured value (PV)
"

"
Over-range
Exceeds the higher limit of "Measuring range (MODE5)" or "Linear
scale (MODE5)". Check "Input type (MODE5)"/input signal.
An alarm event is judged by PV = ∞
"

"
Under-range
Falls below the lower limit of "Measuring range (MODE5)" or
"Linear scale (MODE5)". Check "Input type (MODE5)"/input signal.
An alarm event is judged by PV = -∞
The decimal point position follows "Display decimal point (MODE5)".
Displays the setting value (SV).
"

"
to
"

"
Setting value (SV)
[Displayed SV type]
• Start SV
• SV in program operation (slope/keep)
• SV at REST
[Settable/alterable SV types]
• Executing SV (MODE0)
• SV for program operation (MODE2)
While displaying PV/SV screen, [SV] in the front lights.
If it is STOP or RESET status and "Operation screen SV display (MODEt)" is set to
"MULTI", setting value (SV) and STOP, RESET, or END is displayed alternately.
The decimal point position follows "Display decimal point (MODE5)".
Use the [
∨
] or [
∧
] key to set "Executing SV (MODE0)". The setting range is limited by
"SV limiter (MODE5)". After setting, the set contents of "Executing SV (MODE0)" and
"SV for program operation (MODE2)" will be updated. "Executing SV (MODE0)" cannot
be changed in the program operation RESET status.
[Operation/MODE screen switch]
Press and hold the [MODE] key to display the MODE0 initial screen.
[AUTO/MANUAL output switch]
Press and hold the [>] key to switch the output between AUTO and MANUAL.
When switch to the MANUAL output, it will be switched to the PV/OUT1 (operation
screen) automatically.