Chino DB600 Series - 6-12-2 IR engineering cable (RZ-EC5) connection

INST.No.INE-868G [DB600] General Instruction Manual
- 140 -
6-12 Communication interface
The instrument provides the following standard/optional communication functions.
6-12-1 Engineering port
This is used to connect the instrument with a PC. All models of the instrument have the engineering port
as standard.
The engineering port is located at the bottom of the case (engineering port) for DB630, and at the front (IR
engineering port) and the top of the case (engineering port) for DB650/670. Insert the dedicated USB
engineering cable "RZ-EC4" (sold separately) or IR engineering cable "RZ-EC5" (sold separately) to
establish communication with a PC. (*Not available for DB630)
CHINO prepares the software for parameter setting. It will help you set various parameters easily using
the USB engineering cable and PC.
The communication specification of the engineering port is shown below.
• Communication protocol: MODBUS-RTU
• Communication transmission rate: 9600bps (fixed)
• Communication character: 8-bit length, NON parity, stop bit 1
[DB630] [DB650] [DB670]
[RZ-EC4] (Support DB630/DB650/DB670) [RZ-EC5] (Support DB650/DB670)
RZ-EC4
RZ-EC4
RZ-EC5