Chino DB600 Series - 5-5 MODE3 [Group parameter]; 5-5-1 Setting overview; 5-5-2 Setting item screen and function

INST.No.INE-868G [DB600] General Instruction Manual
- 83 -
5-5 MODE3 [Group parameter]
5-5-1 Setting overview
MODE3 provides the settings for main control parameters.
8 parameters are grouped as one, and you can register an execution No.
When constant value operation and each step of program pattern is performed, a group parameter can be
used.
5-5-2 Setting item screen and function
Setting item Function


▲
SEL ↑ ↓ ▼ SEL
Initial screen
MODE3 initial screen
(Group parameter)
MODE3 (group parameter) initial screen
Pressing the [
∨
] key makes a switch to the MODE2 or MODE1 screen.
Pressing the [
∧
] key makes a switch to the MODE4 screen.
No parameter is set by the [ENT] key.
[Switch to operation initial screen]
Press and hold the [MODE] key to display the screen set on the MODEt operation
initial screen.

□□

▲
SEL ↑ ↓ ▼ SEL
Group
No.
Group No.
(No. for 8 types)
Sets the group No. for parameters in MODE3.
"
□□

"
to
"
□□

"
Parameter No. for 8 types
Use the [
∨
] or [
∧
] key to switch the group No.
No parameter is set by the [ENT] key.
 □□□
□□□

▲
SEL ↑ ↓ ▼ SEL
SV
SV for constant value
operation, 8 types
Sets the SV for constant value operation for 8 types.
"

"
to
"

"
SV for constant value operation
* The setting range is limited by "SV limiter (MODE5)".
Use the [
∨
], [
∧
] and [ENT] keys to set the SV for constant value operation for 8
types.
Use the [>] key to move the cursor to the right digit.
Set the numbers for 8 types at "Group No. (MODE3)".


▲
SEL ↑ ↓ ▼ SEL
Event
Event 1 (8 types) Set the event for 8 types.
"

"
to
"

"
Event value
Heater disconnection alarm: set within a range of 5.0 to 50.0(A).
Timer alarm: set within a range of 0 to 30000(sec).
If "-19999 to -1(sec)" is set, it works in 0sec.
FAIL alarm: setting value is not used for alarm operation.
Use the [
∨
], [
∧
] and [ENT] keys to set the event 1 to 4 for 8 types.
Use the [>] key to move the cursor to the right digit.
Set the numbers for 8 types at "Group No. (MODE3)".


▲
SEL ↑ ↓ ▼ SEL
Event 2 (8 types)


▲
SEL ↑ ↓ ▼ SEL
Event 3 (8 types)


▲
SEL
↑ ↓ ▼
SEL
Event 4 (8 types)