Chino DB600 Series - 2 Mounting and wiring; 2-1 External dimensions; 2-1-1 Unit dimensions

INST.No.INE-868G [DB600] General Instruction Manual
- 12 -
*1 It can be specified when (6) Control output 1 is "1", "3", "5" or "6"
*2 It can be specified when (12) 2 Alarm event output points + Heater disconnection detection is "0" or "1".
*3 When specification with (7) Control output 2, number of alarm event output points is only 1 point [EV 2].
*4 It can be specified when (6) Control output 1 or (7) Control output 2 are "1" or "5" and (10) Remote signal input
+ 2 External signal input points is "0", "5" or "7".
If (6) Control output 1 and (7) Control output 2 are both "1", it can be operated with Control output 1.
*5 Alarm event only functions on mechanical relay, so check for the event function and select it.
*6 For using on multi-output, select one of following models.
Model (6) Control output 1 (7) Control output 2 (12) 2 Alarm event output points +
Heater disconnection detection
DB67153□□□□1□□
SSR drive pulse
output
Current output
Alarm event output [EV2]
DB67153□□□□2□□
SSR drive pulse
output
Current output
Alarm event output [EV2] + Heater
disconnection detection
DB67156□□□□1□□
SSR drive pulse
output
Voltage output
Alarm event output [EV2]
DB67156□□□□2□□
SSR drive pulse
output
Voltage output
Alarm event output [EV2] + Heater
disconnection detection
Alarm event output [EV2] functions as ON-OFF pulse output depending on the setting.
*7 If one of following options is added, select an appropliate code for (13).
Code
Waterproof
specifications
Output scaling
Lower limit
burnout
Square root
calculation
Open-loop system
ON-OFF servo
specifications
1  － － － －
A
*8
－  － － －
B － －  － －
C － － －  －
D － － － － 
E
*8
  － － －
F  －  － －
G  － －  －
H  － － － 
：Added option
*8 It can be specified when the control algorithm is PID control.