INST.No.INE-868G [DB600] General Instruction Manual
- 87 -
□
□□
▲
SEL
↑ ↓
▼
SEL
Status event
Setting*1
"
□
"
Constant value operation in RUN status
"
"
Preset manual status
"
□□
"
Remote input status
"
□
"
SV rising status
"
□
"
SV falling status
"
□
"
Step switch status in program operation
"
□
"
to
"
"
Step 1 status in program operation
to
Step 12 status in program operation
"
□
"
RUN status in program operation
"
□
"
STOP status in program operation
"
□□
"
ADVANCE (stepping) status in program operation
"
"
RESET status in program operation
"
□□
"
END status in program operation
"
"
SV keep status in program operation
*1 Event 1 to 4 (8 types) (MODE3) event value setting propriety
: Set event value,
: Do not use event value
Use the [
∨
], [
∧
] and [ENT] keys to set the event mode.
Set the event No. at "Event No. (MODE4)".
□
□□
▲
SEL
↑ ↓
▼
SEL
Event extension
function
(Event No. 1 to No. 4)
Sets the event extension function.
The function becomes effective when the event mode is alarm event (excluding
heater alarm/timer alarm/FAIL alarm).
"
□□
"
No extension function (normal alarm)
"
□
"
Event standby
"
□
"
Event keep
"
"
Event standby/keep
The display appears only when "Event No. (MODE4)" is set to "
" to
"
".
Use the [
∨
], [
∧
] and [ENT] keys to set the event extension function.
Set the event No. at "Event No. (MODE4)".
□□
▲
SEL
↑ ↓
▼
SEL
Event deadband
(Event No. 1 to No. 4)
Sets the event deadband.
The function becomes effective when the event mode is alarm event (excluding
timer alarm and FAIL alarm).
"
□□
"
to
"
"
0.00 to 200.00 [°C]
The display appears only when "Event No. (MODE4)" is set to "
" to
"
".
Use the [
∨
], [
∧
] and [ENT] keys to set the event deadband.
Use the [>] key to move the cursor to the right digit.
Set the event No. at "Event No. (MODE4)".
▲
SEL
↑ ↓
▼
SEL
Event output phase
(Event No. 1 to No. 9)
Sets the event output phase.
"
"
Normal output phase
Output OFF while event OFF
Output ON while event ON
"
"
Reverse output phase
Output ON while event OFF
Output OFF while event ON
This display is available for the specification with event output.
Use the [
∨
], [
∧
] and [ENT] keys to set the event output phase.
Set the event No. at "Event No. (MODE4)".
"Reverse output phase" does not function while the instrument is turned OFF or
start-up screen is displayed.
To Next Page
Loading...
