Remote Interface Description
5-11
[:SOURce]:SAFEty:PRESet:GB:VOLTage?
This command is for querying ground impedance test open voltage.
[:SOURce]:SAFEty:PRESet:AGC[:SOFTware] < boolean > | ON | OFF
This command is for setting software AGC is open or not.
[:SOURce]:SAFEty:PRESet:AGC[:SOFTware]?
This command is for querying software AGC is open or not. Return character is 1 or 0.
[:SOURce]:SAFEty:PRESet:FCONtinuity < boolean > | ON | OFF
This command is for setting if continue to test the next step when fails the test.
[:SOURce]:SAFEty:PRESet:FCONtinuity?
This command is for querying if FCONtinuity is open or not. It returns character 1 or 0.
[:SOURce]:SAFEty:PRESet:SCREen < boolean > | ON | OFF
This command is for setting the test screen is ON or OFF.
[:SOURce]:SAFEty:PRESet:SCREen?
This command is for querying the test screen is ON or OFF. It returns character 1 or 0.
[:SOURce]:SAFEty:PRESet:KEYboard:SMARt < boolean > | ON | OFF
This command is for setting SMART KEY is open or not.
[:SOURce]:SAFEty:PRESet:KEYboard:SMARt?
This command is for querying SMART KEY is open or not. It returns character 1 or 0.
[:SOURce]:SAFEty:PRESet:TIME:ASTart < numeric value >
This command is for setting the time of waiting to start of GBSS MODE. The setting range
is 0.1~99.9 second. When set to 0, it means GBSS MODE is off.
[:SOURce]:SAFEty:PRESet:TIME:ASTart?
This command is for querying the time of waiting to start of GBSS MODE.
[:SOURce]:SAFEty:PRESet:NUMber:PART <part number>
This command is for setting part number.
[:SOURce]:SAFEty:PRESet:NUMber:PART?
This command is for querying part number.
[:SOURce]:SAFEty:PRESet:NUMber:LOT <lot number>
This command is for setting lot number.
[:SOURce]:SAFEty:PRESet:NUMber:LOT?
This command is for querying lot number.
[:SOURce]:SAFEty:PRESet:NUMber:SERIal <serial number>
This command is for setting serial number format of product, * means universal character.
[:SOURce]:SAFEty:PRESet:NUMber:SERIal?
This command is for querying serial number format of product.
To Next Page
Loading...
