Chroma 61705 - Page 95

Remote Operation
8-21
TRIG
TRIG : STATE?
[SOURce :] PULSe : VOLTage : AC
Description : This command sets AC voltage in the duty cycle of PULSE
mode.
Query Syntax : [SOURce :] PULSe : VOLTage : AC?
Parameters : <NR2>, valid range: 0.0 ~ 150.0 (in low range), 0.0 ~ 300.0 (in
high range)
Return Parameters : <NR2>
[SOURce :] PULSe : VOLTage : DC
Description : This command sets the DC voltage in the duty cycle of PULSE
mode.
Query Syntax : [SOURce :] PULSe : VOLTage : DC?
Parameters : <NR2>, valid range: -212.1 ~ 212.1 (in low range), -424.2 ~
424.2 (in high range)
Return Parameters : <NR2>
[SOURce :] PULSe : FREQuency
Description : This command sets the frequency during the duty cycle of
PULSE mode.
Query Syntax : [SOURce :] PULSe : FREQuency?
Parameters : <NR2>, valid range: 15.00 ~ 1000.00 (unit: Hz)
Return Parameters : <NR2>
[SOURce :] PULSe : SHAPe
Description : This command selects the waveform buffer for PULSE mode.
Query Syntax : [SOURce :] PULSe : SHAPe?
Parameters : A | B
Return Parameters : A | B
[SOURce :] PULSe : SPHase
Description : This command sets the start phase angle of duty cycle of
PULSE mode.
Query Syntax : [SOURce :] PULSe : SPHase?
Parameters : <NR2>, valid range: 0.0 ~ 359.9
Return Parameters : <NR2>
[SOURce :] PULSe : COUNt
Description : This command sets the number of times that the pulse is
executed before it is completed.
Query Syntax : [SOURce :] PULSe : COUNt?
Parameters : <NR2>, valid range: 0 ~ 65535
Return Parameters : <NR2>
[SOURce :] PULSe : DCYCle
Description : This command sets the duty cycle of PULSE mode.
Query Syntax : [SOURce :] PULSe : DCYCle?
Parameters : <NR2>, valid range: 0 % ~ 100 %
Return Parameters : <NR2>