2-28 Installation
5160 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3207-001 Standard Revision A
Copyright
©
2013 Ciena
®
Corporation September 2013
3 Gently pull on the optic to make sure that it has seated properly.
You have installed the pluggable optic.
WARNING: Optic operation should be verified by observing the status LEDs. Do not
look into the laser to verify operation. For additional laser safety information, refer to
“Important Safety Information” on page 2-3.
WARNING: This is a Class 1 laser product. Only optics that have been qualified by
Ciena should be used in this product. See Packet Networking Transceivers
Reference (009-2011-602) for the list of supported optics.
These optics have been demonstrated to meet Class 1 eye safe levels by a
Nationally recognized Authority(s) such as The Food and Drug administration's
21CFR1040 Laser Energy Source, UL 60950 Information Technology equipment and
European norms EN60825-1 and EN60825-2. Failure to use laser transceivers which
meet these standards could result in eye damage to users or service personnel
working around the equipment.
To Next Page
Loading...
