Mounting Options 8-11
5160 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3207-001 Standard Revision A
Copyright
©
2013 Ciena
®
Corporation September 2013
Figure 8-7
Back side of right bracket
3 Position the chassis in place in the frame.
4 Install four customer supplied screws in the slots on both the left and right
brackets.
5 Install the cable support on the mounting brackets using either the Inner or
Outer screw position and the two longer 8-32 screws provided in the kit. One
screw will be used per bracket. Figure 8-2 on page 8-4 shows the Cable
Support installed on the mounting bracket, and Figure 8-8 shows the Inner
and Outer mounting holes available on the bracket.
Figure 8-8
Front view of right bracket, showing mounting holes
6 Use the Cable Support Bracket to dress and secure the cables. Use local
practices to secure the cables. Ensure that the weight of the cable is
supported and does not drag on the plug. For detailed cabling information,
see the hardware installation manual for the unit.
You have successfully mounted the unit.
Inner cable bracket screw position
Outer cable bracket screw position
Frame mounting holes
To Next Page
Loading...
