3-16 Turning Up the System
5160 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3207-001 Standard Revision A
Copyright
©
2013 Ciena
®
Corporation September 2013
Procedure 3-10
Logging out of the System
Note: Before you disconnect from the system, ensure that you have
saved the configuration using the
configuration save command.
Step Action
1 At the prompt, enter the following command:
exit
2 Remove the cable connecting the console port to the serial port on the
terminal or PC.
You have logged out of the system.
To Next Page
Loading...
