Cimbali M34 SELECTRON - Page 54

7 8
9
21 4
5 6
11 12
15 16
17
13
3
10
14
English
16 EN
Remove the filter holder
from the coffee group.
Using a brush, clean the
cover gasket.
Hold down the coffee circuit
washing key
(26) for a
few seconds.
SEQUENTIAL WASHING
Procedure to effect at the end of the work day on all groups or when signaled by the machine.
The simultaneous washing
mode (preset mode) will
appear on the display.
to change sel.
to confirm
Use the “+” (30) and
“-” (31) keys to pass to the
Sequential Washing cycle.
The scrolling icons of the
machine groups will appear
on the display.
to change sel.
to confirm
&RQ¿UPWKHZDVKLQJPRGHV
using the key
OK
. The
screen will display:
Insert the rubber disk into
WKH¿OWHUKROGHUZLWKLWV¿OWHU
Pour in a packet or dosing
cupful of detergent powder.
26 SEP 12 15:15
INSERT. FILTER HOLDER
GROUP 1
push
to confirm
26 SEP 12 15:15
GR1 WASH
Press the coffee circuit
wash key
(26).
The Group 1 wash cycle will
start and the "GR1 WASH"
message will appear on the
display.
At the end of the group 1
wash cycle, the message
"REMOVE FILTER
HOLDER GROUP 1" will
appear.
The message "GR1 RINSE"
will appear.
At the end of the group 1
rinse cycle, the message
"EXECUTE GROUP 2
WASH" will appear.
Repeat the operations
described above for all
machine groups.
5HPRYHWKH¿OWHUKROGHU
Press the coffee circuit
wash key
(26).
Hook the filter holder to
Group 1.
26 SEP 12 15:15
REMOVE FILTER HOLDER
GROUP 1
push
to confirm
26 SEP 12 15:15
GR1 RINSE
26 SEP 12 15:15
GROUP 2 WASH
push
to confirm