Cimbali M34 SELECTRON - Component Cleaning Procedures

1 32
4 5
A
8
12
English
18 EN
Put a liter of cold water in a
suitable container and add
detergent.
5HPRYHWKH¿OWHUVIURPWKH¿OWHUKROGHUV
Soak the filters and the
¿OWHUKROGHUVLQWKLVVROXWLRQ
for about 15 minutes.
3ODFHWKH¿OWHUVEDFNLQWKH¿OWHUKROGHUPDNLQJVXUHWKDW
the anchoring spring (ARIWKH¿OWHULVLQLWVVORW
FILTER-HOLDERS - 7KLVRSHUDWLRQPXVWEHPDGHRQDOOWKH¿OWHUKROGHUVDWWKHHQGRIHDFKZRUNLQJGD\
Remove any residue with a sponge and rinse well with
cold water.
When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested
wash cycle is pressed (key
26) and the instructions on
the display are followed, the wash cycle is performed and
the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.
If the coffee wash circuit key
(26) is pressed, the previous
message will be integrated as shown:
When the "INSERT FILTER HOLDER - GROUP 1" mes-
sage appears, the block message for Group 1 disappears.
The block messages for groups still to be washed appear
in alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
GROUP 1 LOCKED
EXECUTE WASHING
GROUP 1 LOCKED
EXECUTE WASHING
INSERT FILTER HOLDER
GROUP 1
CHANGING THE WATER IN THE BOILER3URFHGXUHWRFDUU\RXWDWOHDVWRQFHDGD\
Keep a hot water distributor key (12) pressed down for
approximately 5 seconds.
The following message will be displayed: “WATER
CHANGE”. The water from the boiler will drain from the
hot water nozzle (8) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
IXQFWLRQVDQGWKHERLOHUZLOOEHUH¿OOHGZLWKIUHVFKZDWHU
Block function