2
Enter Setup
1660 Barcode Scanner
User Guide
GETTING FAMILIARIZED WITH 1660/1661 AND 3610
INSTALLING BATTERIES TO 1660/1661
1) Hold the scanner face down in one hand.
2) Press the battery lid release and slide the battery lid.
3) Remove the battery lid by the other hand.
4) Hold the scanner still and insert the battery or batteries into the battery
compartment.
For 1660, install two AAA Alkaline batteries into the battery compartment, each in
the right direction.
5) Replace the battery lid and lock it firmly.
6) Hold down the [Power/Delete] key for about 2 seconds to turn on the scanner.
The scanner will respond with a long beep (high tone) and its LED indicator will
become solid red and go off quickly.
Note: (1) To turn off the scanner, press the [Power/Delete] key for 2 seconds. The
scanner will respond with two short beeps (high tone) and the LED will finally
become solid red. Release the key then. Otherwise, let the scanner turn off
automatically in specific circumstances. Refer to settings of “
Auto Power Off”.
(2) For shipping and storage purposes, save the scanner and the batteries
separately. This will keep the batteries in good condition for future use.
To Next Page
Loading...
Need help?
General
