3
Update
Introduction
CHARGING THE BATTERY FOR 1661
The battery may not be charged to full for shipment. When you first receive the package,
you will need to charge the battery to full before using the scanner. For 1661, use the
Direct USB cable to connect the scanner to PC for charging. It takes approximately 4
hours to charge the battery to full. Refer to
1.13 1661 Using Direct USB Cable.
Note: Battery charging stops when the temperature drops below 0°C or exceeds 40°C. It
is recommended to charge the battery at room temperature (18°C to 25°C) for
optimal performance.
1) Install the battery to 1661.
2) Connect 1661 to your computer or notebook via the USB cable.
3) The scanner LED will be flashing red during charging.
When the charging is done, the LED will turn off.
When charging error occurs, the LED will turn solid red. For example, a bad or
missing battery.
To Next Page
Loading...
Need help?
General
