48
Enter Setup
1660 Barcode Scanner
User Guide
1.13 1661 USING DIRECT USB CABLE
1661 supports Direct USB interface for charging the battery and/or sending data to host
in memory mode. Refer to
1.2.2 Memory Mode.
Note: The scanner is not allowed to function when it is solely on USB power and without
a battery loaded.
1.13.1 DIRECT USB INTERFACE
When it is set to Memory Mode and connected to computer via the Direct USB cable, the
default output interface becomes “Direct USB Virtual COM”. You may change it to “Direct
USB HID”.
For details on configuring the interface settings, refer to the following sections:
2.6 Direct USB HID (1661 Memory Mode Only)
2.7 Direct USB Virtual COM (1661 Memory Mode Only)
*Activate Direct
USB Virtual COM
Activate Direct
USB HID
1.13.2 DISABLE DIRECT USB INTERFACE
When connecting the Direct USB cable, you may have the scanner read the “Disable
Direct USB” barcode in advance to avoid sending data to host in memory mode via the
cable. It will then allow charging the battery only.
Disable Direct USB
To Next Page
Loading...
Need help?
General
