To Next Page

To Previous Page

Update

Chapter 2

Selecting Output Interface

2.2 BT SPP SLAVE

For BT SPP Slave, refer to Chapter 3 – Setting up a WPAN Connection for related

connection settings.

2.2.1 ACTIVATE BT SPP SLAVE MODE

This is SPP Slave Mode.

Activate BT SPP,

Slave Mode

2.2.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254,

to match the computer response time of the keyboard interface. Such delay time is

inserted between every function code (0x01 ~ 0x1F) being transmitted. The longer the

delay time is, the slower the transmission speed will be.

Value

Delay Time Value Delay Time

0 Disable 195 ~ 204 200 millisecond

1 ~ 14 10 millisecond 205 ~ 214 210 millisecond

15 ~ 24 20 millisecond 215 ~ 224 220 millisecond

25 ~ 34 30 millisecond 225 ~ 234 230 millisecond

35 ~ 44 40 millisecond 235 ~ 244 240 millisecond

45 ~ 54 50 millisecond 245 ~ 254 250 millisecond

… …

Inter-Function

Delay… (*0~254)

1) Read the barcode above to specify the inter-function delay.

2) Read the “

Decimal Value” barcode on page 217 for the desired inter-function delay

(millisecond).

3) Read the “Validate” barcode on the same page to complete this setting.

CipherLab 1660 User Manual

Other manuals for CipherLab 1660