1.11 Feb. 02, 2010
Modified: 2.2 BT SPP Slave
Modified: 2.3 BT SPP Master
1.10 Jan. 05, 2010
Modified: Restore System Defaults — add key combination
Modified: 1.1.1 How to Operate the Scanner — add key combination
to restore defaults during operation
Modified: 1.1.2 Auto Power Off & Power-Saving
Modified: 2.1.1 Activate BT HID & Select Keyboard Type —
add
Turkish
Modified: 2.1.5 HID Character Transmit Mode
Modified: 2.3.1 Activate USB HID & Select Keyboard Type —
add
Turkish
Modified: 2.3.4 HID Character Transmit Mode
Modified: 4.9.4 Security Level
Modified: 5.2.2 Symbologies for Character Substitution (All 3 Sets)
— add ISBT 128
Modified: 5.4.1 Select Pre-defined Code ID — add ISBT 128
Modified: 5.4.2 Change Code ID — add ISBT 128
Modified: 5.5 Length Code — add ISBT 128
Modified: 6.3.1 Applicable Code Type (for Editing Format) —
add
ISBT 128
1.09 July 07, 2009
Modified: 1.1.2 Auto Power Off & Power-Saving — add setup barcode
for Power-Saving setting (101021)
Modified: 3.2.2 Configure Related Settings — Authentication
Modified: Appendix II Host Serial Commands
1.08 Apr. 29, 2009
Modified: Using 3610 — change LED of Serial command mode
(Blue,
flashing)
Modified: 1.1.2 Auto Power Off — change LED on/off ratio, etc.
Modified: 1.3 LED Indicator — change LED on/off ratio, etc.
Modified: 1.4 Beeper — add notification for PIN code, etc.
Modified: 3.1.1 Connect to 3610 — One beep for each setup barcode
Modified: 4.12.3 Code Length Qualification — MSI must include
checksum
Modified: 5.6.2 Activate the Concatenation of Barcodes —
add
description of LED and beeper
Modified: Appendix I Firmware Upgrade
Modified: Appendix II Host Serial Commands
Modified: Appendix IV (Reject Random PIN Request)
1.07 Apr. 09, 2009
New: BT Transponder (3610)
Modified: 1.2.1 Transmit Buffer — add setup barcodes
Modified: 1.4 Beeper — Transmit Buffer Disabled
Modified: 2.1 BT HID — change setup barcode (100006)
New: 2.3 USB HID via 3610 — add setup barcode (100005)
New: 2.4 USB Virtual COM via 3610 — add setup barcode (100004)
To Next Page
Loading...
Need help?
General
