177
Apply Configuration to Device
DEPLOY ALL SETTINGS TO DEVICES
User can convey the project settings to the device which is connected with your PC where
ADC program is installed. Once you finish configurating all the settings of a project, follow
the steps to proform the deploying:
1) Connect your devices with your PC. Please make sure that the debugging mode is
enabled. (Please refer to How Do I Enable Debugging Mode on My Device?)
2) Check the “
Specify your deployment task(s)” part to confirm the settings to be deployed
to your device.
3) Click the “Deploy ” button on Toolbar.
2
3
To Next Page
Loading...
