Circutor SVGm-4WF-020M-400 - RACK-TYPE Svgm: Svgm-3 WF-100 R and Svgm-4 WF-069 R

132
SVGm
Instruction Manual
ENGLISH
It is recommended to fix the connection cables to the holes that facilitate the transport
and installation of the device (Figure 4), so that the terminals are not subjected to any
mechanical stress.
3.6.2.- RACKTYPE SVGm: SVGm-3WF-100R and SVGm-4WF-069R
The SVGm type Rack connection terminals are located at the front and rear of the device.
Table 16: List of terminals.
Device terminals
1: ETHERNET, Ethernet Connector 11: S2, Current input L2
2: RBUS, Terminator switch for parallel connection
12: S1, Current input L3
3: IN, Input for parallel connection 13: S2, Current input L3
4: OUT, Output for parallel connection 14: L1, Mains connection L1
5: A, RS-485 communications 15: L2, Mains connection L2
6: B, RS-485 communications 16: L3, Mains connection L3
7: S, RS-485 communications 17: N, Mains connection N
8: S1, Current input L1 18: N, Mains connection N
9: S2, Current input L1 19: Earth connection
10: S1, Current input L2
S1
S1
S1
S2
S2
S2
L1 L2
L3
RS485
A
B
S
LINK
IN
OUT
ETHERNET
1
2 3 4
5
6
8
9
10
11
12
13
R
BUS
7
Figure 13: Rack-type SVGm terminals (terminals at the front of the device).
14
15
16
17
18
19
Figure 14: Rack-type SVGm terminals (terminals at the rear of the device).