161
Instruction Manual
SVGm
ENGLISH
Table 22 (Cont.) : Alarm messages.
Alarm messages
Hardware failure
Description Possible hardware failure detected.
Corrective
action
Contact the Technical Service.
Selt-test failed
Description The self-test system has detected a fault.
Corrective
action
Contact the Technical Service.
Temperature
Description Very high ambient temperature.
Corrective
action
Power limited below 50% due to temperature. Check ambient temperature, dirt at the air intake and
fans.
DSP failure
Description Fault in the DSP
Corrective
action
The DSP has suffered an unexpected fault. Appears when updating the software. In any other case,
contact TAS.
5V supply failure
Description Power supply failure.
Corrective
action
Contact Technical service.
Internal comms error
Description Failure in internal communications.
Corrective
action
Restart. Contact the Technical Service.
(1)
Alarm messages available with software versions DSP ≥ 1.61 and HDMI ≥ 1.2006.
6.8.- WARNINGS
Note: This screen is not visible on the “slave” devices.
When the device generates a warning, it will continue to operate, but the symbol will be displayed
on the main screen.
On pressing the key; if there are active warnings, the screen shown in Figure 49, will be dis-
played and the user will be asked for confirmation to continue with the static generator start-up pro-
cess.
Figure 49: Confirm screen.
To Next Page
Loading...