166
SVGm
Instruction Manual
ENGLISH
Figure 54: Calibrate touch sensor.
Note: You have accessed the calibration screen by accident, wait until the line that surrounds the
central circle is complete and you will be returned automatically to the information screen of the
device (Figure 53).
Use the and keys to navigate through the different display screens.
6.12.- SLAVE DEVICE STATUS
Note: This screen is not visible on the “slave” devices.
Note: This screen is only displayed if a system has been configured with devices in parallel.
This screen, Figure 55, shows the status of each “slave” device.
Figure 55: Slave device status screen (1).
The “slave” to be checked can be selected from the top tab, by serial number.
Select the “slave”; the screen shown in Figure 56 will be displayed. This screen shows the Model, Type
and Serial number of the device, as well as its status, active alarms and the temperature of the IGBTs
and inductors.
To Next Page
Loading...