172
SVGm
Instruction Manual
ENGLISH
7.5.- cos Φ
Note: This screen is not visible on the “slave” devices.
The device has two reactive power compensation modes (Figure 63).
Figure 63: Configuration screen: cos Φ (Mode 1 and Mode 2).
● Mode 1
In this mode, cos Φ is set to a fixed value. The device will attempt to ensure that the reactive power on
the mains side corresponds to the specified cos Φ.
● Mode 2
In this mode, two limits are defined to form an acceptance range. The device will adjust the reactive
power on the mains side to keep cos Φ within the specified acceptance range.
This mode minimises the amount of power used by the device to compensate for reactive power, thus
reducing its energy consumption.
Table 28: Configuration values: cos Φ.
cos Φ
Range of values 0.7 ... -0.7
Press the key to access the next configuration step
Press the key to access the main screen of the device without saving the configuration values.
To Next Page
Loading...