133
Instruction Manual
SVGm
ENGLISH
3.6.3.- CABINETTYPE SVGm
CIRCUTOR has two types of cabinets: cabinets with connections at the top and cabinets with connec-
tions at the bottom.
Note: Cabinets with connections at the top are only available in the SVGm-3WFxxxC-480 and SVGm-
4WF-xxxC-400.
There are sliding windows at the bottom of the cabinet so that the connection wiring can be slotted
inside, Figure 15. These windows can be removed and machined if it is considered necessary to use a
cable gland.
Figure 15: Sliding windows for the connection wiring.
You should never remove the cover closest to the front part.
Cabinets with connections at the top have a sheet in the upper part of the cabinet which can be ma-
chined as shown in Figure 16, to insert the connection wiring.
72
80 80
80
138
75
Unidades en mm. / Units in mm.
Figure 16: Machining a cabinet with connections at the top.
The current input and the communication ports must be connected to the “master” device, which is
the located at the top of the cabinet. This connection is described in “3.6.2.- RACK-TYPE SVGm: SVGm-
3WF-100R and SVGm-4WF-069R”.
To access the current input and mains connections, loosen the screws in the lower front cover (in
To Next Page
Loading...