EasyManua.ls Logo

Circutor SVGm-4WF-020M-400 - Ethernet Communications; Device Information

Circutor SVGm-4WF-020M-400
218 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
165
Instruction Manual
SVGm
ENGLISH
6.10.- ETHERNET COMMUNICATIONS
In this screen, Figure 52, the IP address of the device and the netmask are shown.
Figure 52: Communications.
Use the and keys to navigate through the different display screens.
6.11.- DEVICE INFORMATION
In this screen, Figure 53, the serial number, HMI and DSP versions of the device are shown.
Figure 53: Device information.
The touch panel of the display is calibrated from factory, but depending on the installation conditions,
it may be necessary to recalibrate it.
It is recommended to use a soft tip pointer (take care not to damage the display) and press icon
. The calibration screen is shown below, Figure 54.

Table of Contents