Circutor SVGm-4WF-020M-400 - Master;Single Device Display Screens

154
SVGm
Instruction Manual
ENGLISH
6.- DISPLAY
6.1.- MAIN SCREEN
6.1.1. - SINGLE OR MASTER DEVICE
Figure 40 shows the main screen of a “single” or “master” device.
Arrancando ...
RUN / STOP key
RESET key
Main
% of power
Active Power
Reactive Power
Cos Ф
Status messages
Active Power
Reactive Power
Cos Ф
Load
Figure 40: Main screen.
It shows the Cos ɸ, Active and Reactive Power values in the Main and in the Load. And the % of SVG
power used.
Note: If the Remote Control option has been selected (“7.9 - REMOTE CONTROL”) for the device to check
the Active and Reactive Power values through an external analyzer, “REMOTE” is shown on the Grid
side.
The key allows you to restart the device if an alarm has been generated and this has been
resolved.
The / key is the start and stop key of the SVGm.
Use the and keys to navigate through the different display screens.
In the upper part of the screen, a message with the current status of the device is shown (Table 21).
Table 21: Status messages
Status messages
Starting
Description The SVGm is starting up.
Init
Description The device is starting the systems.