170
SVGm
Instruction Manual
ENGLISH
● Type, device range:
Table 25: Configuration values: Type.
Type
Possible values
30 kvar: 20.7 and 30 kvar model.
60 kvar: 41.4 and 60 kvar model.
75 kvar: 51.7 and 75 kvar model.
67 kvar: 67 kvar model.
100 kvar: 69 and 100 kvar model.
Press the key to access the next configuration step
Press the key to access the main screen of the device without saving the configuration values.
7.3.- INSTALLED DEVICES
The type of device is configured in this screen, Figure 61.
Figure 61: Configuration screen: Installed units
● Type of device: Master / Single / Slave
In this screen the type of device is selected, the possible options are:
Single: select this option if the SVGm does not have static generators connected in parallel.
Master: select this option if the static generator is going to be used as the “master” of a
group of devices in parallel.
Slave: select this option if the device is going to be used as the “slave” of a group of devices
in parallel.
Once the device has been configured as the “slave”, the next configuration step is shown in
section “6.10.- ETHERNET COMMUNICATIONS”.
Note: The and / keys are disabled in the slave devices.
Press the key to access the next configuration step
To Next Page
Loading...